View Complete Thread | FoxWeb Forum Home
Search:
Date:    Msg ID:   
From:    Thread:   
Subject:   
I am not sure I understand your question.  The FoxWeb Control Center does not have an entry for you to specify where the Run-Time DLLs are located.  If you enable the Use Run-Time DLL option then FoxWeb will find the DLLs automatically, as long as they are installed in the correct location, as described below.

FoxWeb Support Team
support@foxweb.com

Sent by Joe Goldsmith on 03/17/2002 08:48:33 PM:
Hi. I just noticed this post about where VFP7 runtime files are located. Which DLL should I point the Control Center to?

Sent by FoxWeb Support on 02/05/2002 08:04:05 PM:
The VFP6 Run-Time DLLs are required in order to run the FoxWeb Control Center, so they are installed by default.  You do not need to install them manually.  The FoxWeb setup program installs them in their default location, which for VFP 6 is the system directory.  Note that starting from VFP 7 the recommended location has changed to C:\Program Files\Common Files\Microsoft Shared\VFP.

FoxWeb Support Team
support@foxweb.com

Sent by Stephen Cox on 02/03/2002 12:49:23 AM:
Hi, where do I place the VFP6 dll's and runtime exe? Also, do I have to register the dll's?  I'm using VFP 7, and I know I need these files for FoxWeb.

thanks- scox